itgle.com

If an Ethernet port on a router was assigned an IP address of 172.1.1.1/20,what is the maximum number of hosts allowed on this subnet?()A、4094B、1024C、8190D、2046E、4096

题目

If an Ethernet port on a router was assigned an IP address of 172.1.1.1/20,what is the maximum number of hosts allowed on this subnet?()

  • A、4094
  • B、1024
  • C、8190
  • D、2046
  • E、4096

相似考题
更多“If an Ethernet port on a router ”相关问题
  • 第1题:

    A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?()

    A. The source and destination addresses

    B. The destination port number

    C. The destination address

    D. The source address

    E. All of the above


    参考答案:D

  • 第2题:

    Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()

    A.The Router1 WAN port is configured as a trunking port.

    B.The Router1 port connected to Switch1 is configured using subinterfaces.

    C.The Router1 port connected to Switch1 is configured as 10 Mbps.

    D.The Switch1 port connected to Router1 is configured as a trunking port.

    E.The Switch1 port connected to Host B is configured as an access port.

    F.The Switch1 port connected to Hub1 is configured as full duplex.


    参考答案:B, D, E

  • 第3题:

    A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port()。

    • A、This is a 10 Mb/s switch port
    • B、This is a 100 Mb/s switch port
    • C、This is an Ethernet port operating at half duplex
    • D、This is an Ethernet port operating at full duplex
    • E、This is a port on a network interface card in a PC

    正确答案:C

  • 第4题:

    A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?()

    • A、This is a 10 Mb/s switch port.
    • B、This is a 100 Mb/s switch port.
    • C、This is an Ethernet port operating at half duplex.
    • D、This is an Ethernet port operating at full duplex.
    • E、This is a port on a network interface card in a PC

    正确答案:C

  • 第5题:

    PCA、PCB分别与S3610交换机SWA的端口Ethernet1/0/2、Ethernet1/0/3相连,服务器与端口Ethernet1/0/1 相连。如果使用端口隔离技术使PC间互相隔离,但PC都能够访问服务器,则需要在交换机上配置哪些命令?()

    • A、[SWA] port-isolate enable
    • B、[SWA-Ethernet1/0/2] port-isolate enable
    • C、[SWA-Ethernet1/0/3] port-isolate enable
    • D、[SWA-Ethernet1/0/1] port-isolate uplink-port

    正确答案:B,C,D

  • 第6题:

    If an Ethernet port on a router was assigned an IP address of 172.1.1.1/20,what is the maximum number of hosts allowed on this subnet?()

    • A、4094
    • B、1024
    • C、8190
    • D、2046
    • E、4096

    正确答案:A

  • 第7题:

    The Peanut router is able to successfully ping the Serial 0 and Ethernet 0 interface of the Popcorn router, but a ping issued to the Ethernet 1 interface fails. Based on the above output, what are the potential causes of this problem?()

    • A、The Popcorn router is not forwarding RIP updates.
    • B、The Popcorn router did not include network 192.168.12.0 in its routing configuration.
    • C、The Ethernet1 interface of the Popcorn router is shutdown.
    • D、The clockrate is not present in the configuration of one of the routers.
    • E、The Serial interface of the Popcorn router is not operating.

    正确答案:B,C

  • 第8题:

    The ERX Edge Router is configured for PPP over Ethernet without using VLAN tagging. How many PPP over Ethernet major interfaces can be configured per port?()

    • A、1
    • B、100
    • C、2048
    • D、4096

    正确答案:A

  • 第9题:

    单选题
    A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?()
    A

    The source and destination addresses

    B

    The destination port number

    C

    The destination address

    D

    The source address

    E

    All of the above


    正确答案: D
    解析: 暂无解析

  • 第10题:

    单选题
    Companycom wants to reduce the number of copper, Ethernet adapters on their 4 way p5 570 running AIX 5.3 used in each of the four LPARs. Companycom has one database LPAR, two application LPARs, and one web LPAR. Only the Web LPAR needs to communicate with the outside world. What is the minimum number of Ethernet adapters that should be provided to ensure redundancy and no single point of failure?()
    A

    One single port Ethernet adapter

    B

    Four dual port Ethernet adapters

    C

    Two single port Ethernet adapters

    D

    Eight single port Ethernet adapters


    正确答案: B
    解析: 暂无解析

  • 第11题:

    单选题
    在华为AR路由器上,将接口配置为本地观察端口的命令是()
    A

    Observe-port interface Ethernet2/0/3

    B

    Mirror-port interface Ethernet2/0/3

    C

    Monitor-port interface Ethernet2/0/3

    D

    Server-port interface Ethernet2/0/3


    正确答案: B
    解析: 暂无解析

  • 第12题:

    单选题
    A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?()
    A

    This is a 10 Mb/s switch port.

    B

    This is a 100 Mb/s switch port.

    C

    This is an Ethernet port operating at half duplex.

    D

    This is an Ethernet port operating at full duplex.

    E

    This is a port on a network interface card in a PC


    正确答案: E
    解析: 暂无解析

  • 第13题:

    If an Ethernet port on router was assigned an IP address of 172.16.112.1/20, what is the maximum number of hosts allowed on this subnet?()

    A. 1024

    B. 2046

    C. 4094

    D. 4096

    E. 8190


    参考答案:C

  • 第14题:

    If an ethernet port on a router was assigned an IP address of 172.16.112.1/20, what is the maximum number of hosts allowed on this subnet()。

    A.1024

    B.2046

    C.4094

    D.4096

    E.8190


    参考答案:C

  • 第15题:

    You are given a PC, a router, and a cable. Select the correct combination that will allow you to log into the router locally using a terminal emulation program such as HyperTerminal.()

    • A、Connect the PC's COM port to the router's console port using a straight-through cable.
    • B、Connect the PC's COM port to the router's console port using a rollover cable.
    • C、Connect the PC's COM port to the router's ethernet port using a straight-through cable.
    • D、Connect the PC's ethernet port to the router's ethernet port using a rollover cable.
    • E、Connect the PC's ethernet port to the router's ethernet port using a straight- through cable.

    正确答案:B

  • 第16题:

    要在路由其上开启快速转发功能,下列哪个命令是正确的?()

    • A、[Router]ipfast-forwardingenable
    • B、[Router]ipfast-forwardinginbound
    • C、[Router-Ethernet0/1]ipfast-forwardingenable
    • D、[Router-Ethernet0/1]ipfast-forwardinginbound

    正确答案:D

  • 第17题:

    PCA、PCB分别与S3610交换机SWA的端口Ethernet1/0/2、Ethernet1/0/3相连,服务器与端口Ethernet1/0/1相连。如果使用端口隔离技术使PC间互相隔离,但PC都能够访问服务器,则需要在交换机上配置哪些命令?()

    • A、[SWA]port-isolateenable
    • B、[SWA-Ethernet1/0/2]port-isolateenable
    • C、[SWA-Ethernet1/0/3]port-isolateenable
    • D、[SWA-Ethernet1/0/1]port-isolateuplink-port

    正确答案:B,C,D

  • 第18题:

    n the case of Ethernet transport, which two types of attachment circuits does L2TPv3 support? ()

    • A、port tunneling on the Ethernet subinterface
    • B、VLAN tunneling on the Ethernet trunk
    • C、port tunneling on the Ethernet interface
    • D、VLAN tunneling on the Ethernet VLAN subinterface
    • E、port tunneling on the Ethernet trunk

    正确答案:C,D

  • 第19题:

    A customer is deploying a new database on a PS701 Blade in a BladeCenter H, and requires redundant network and SAN adapters. Which configuration supports the customer requirement?()

    • A、Configure 2 CFFh combination fibre channel / gigabit Ethernet adapters
    • B、Configure 1 CFFh 2-port fibre channel adapter and 1 CIOv 2-port gigabit Ethernet adapter
    • C、Configure 1 CIOv 2-port fibre channel adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter
    • D、Configure 1 CIOv 2-port gigabit Ethernet adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter

    正确答案:C

  • 第20题:

    Which of the following is a true statement when promiscuous mode is enabled on an Integrated Virtual Ethernet?()

    • A、 The physical port can be used as part of a Shared Ethernet Adapter (SEA).
    • B、 All physical ports on the Host Ethernet Adapter (HEA) default to promiscuous mode.
    • C、 Multiple logical ports can be assigned to a physical port if that logical port is in promiscuous mode.
    • D、 All physical ports that belong to the same port group will be set to promiscuous mode on the Host Ethernet Adapter (HEA).

    正确答案:A

  • 第21题:

    多选题
    The Peanut router is able to successfully ping the Serial 0 and Ethernet 0 interface of the Popcorn router, but a ping issued to the Ethernet 1 interface fails. Based on the above output, what are the potential causes of this problem?()
    A

    The Popcorn router is not forwarding RIP updates.

    B

    The Popcorn router did not include network 192.168.12.0 in its routing configuration.

    C

    The Ethernet1 interface of the Popcorn router is shutdown.

    D

    The clockrate is not present in the configuration of one of the routers.

    E

    The Serial interface of the Popcorn router is not operating.


    正确答案: C,B
    解析: 暂无解析

  • 第22题:

    单选题
    The ERX Edge Router is configured for PPP over Ethernet without using VLAN tagging. How many PPP over Ethernet major interfaces can be configured per port?()
    A

    1

    B

    100

    C

    2048

    D

    4096


    正确答案: A
    解析: 暂无解析

  • 第23题:

    单选题
    Which Cisco Small Business router features a 4-port Fast Ethernet integrated switch but not wireless capabilities?()
    A

     RVS4000

    B

     RVL200

    C

     RV016

    D

     RV082


    正确答案: C
    解析: 暂无解析

  • 第24题:

    单选题
    A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port()。
    A

    This is a 10 Mb/s switch port

    B

    This is a 100 Mb/s switch port

    C

    This is an Ethernet port operating at half duplex

    D

    This is an Ethernet port operating at full duplex

    E

    This is a port on a network interface card in a PC


    正确答案: D
    解析: 暂无解析