Companycom has five LPARs, but only one CD drive. How should the CD drive be shared among all the users without system administrator action?（）A、Allocate the CD to the VIO Server and NFS export the CD to the user LPARsB、Allocate the CD to one of the user L

第1题：

A system administrator has successfully backed up the VIOS software and is ready to perform a VIOS software update. Which command will the administrator use to update the software from a CD？ （）

• A、 smit update_all
• B、 geninstall -d /dev/cd0 all
• C、 installp -acgX -d /dev/cd0 all
• D、 updateios -dev /dev/cd0 -accept -install

第2题：

A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）

• A、Optical drive
• B、Power supply
• C、CMOS battery
• D、CD-ROM disk

第3题：

A user is trying to boot a desktop PC from their A: drive. Which of the following devices is the userdescribing？（）

• A、The floppy drive
• B、The hard drive
• C、The CD-ROM drive
• D、The DVD-ROM drive

第4题：

A defective CD-ROM drive is replaced with a new CD-ROM drive. The new CD-ROM drive is able to read any CD that it accesses， but music CDs do not play music. What is the MOST likely cause of this problem？（）

• A、The audio cable is not connected to the drive.
• B、The ribbon cable is not connected.
• C、The power cable is not connected.
• D、The CD-ROM drivers are not installed.

第5题：

An administrator is installing Windows Server 2003 via CD on a new server with an SAS RAID array.When the administrator reaches the option to select the target installation drive， there are no drives listed. Which of the following is the FIRST thing the administrator should do？（）

• A、 Restart the installation via WDS.
• B、 Shut down the server and check that all RAID drives are connected properly.
• C、 Restart the installation from CD and press F6 to install RAID drivers.
• D、 Go into the BIOS and set all RAID drives to compatibility mode.

第6题：

A server is being set up at a client location. The system has been powered up for a clean install of the base OS. The CD is in the drive. After 5 minutes, the system is hung. There is no activity with the CD-ROM drive and nothing to select on the screen. Which of the following procedures should be performed next?（）

• A、Boot off diskette and change boot device to CD
• B、Change the bootlist for normal mode and reboot
• C、Reboot and press 5/F5 after keyboard is displayed on the screen
• D、Press enter to open SP menus once OK is showing in the LEDs

第7题：

Companycom has just installed a p5 595 with four uncapped LPARs in a shared processor pool. The system and profile settings are still in their default states. One of the LPARs has an application that is consuming all of the available shared processor resources. Users of this application are complaining about response time. Which of the following changes to the slow LPAR would improve response time?（）

• A、Enable SMT
• B、Reduce the weight
• C、Renice the process
• D、Increase the weight

第8题：

Companycom is using shared processor LPARs exclusively, including the Virtual IO Server. The users are complaining about response time. The application LPARs can be heavy processor users. The Virtual IO Server has been measured to be processor constrained. How should the Virtual IO Server's shared processor LPAR be configured?（）

• A、Capped and with a lower share
• B、Uncapped and with a lower share
• C、Uncapped and with a higher share
• D、Capped and with no change in share

第9题：

You network contains a server named Server1. You have a computer named Computer1 that runs Windows XP Professional. Employees log on to Computer1 by using local user accounts. You need to configure the user profiles on Computer1 to be stored on Server1. What should you do?（） 

• A、On Computer1, map a drive to an administrative share on Server1.  Configure each user's profile path to point to the mapped drive. 
• B、Create a shared folder on Server1.  Assign Full Control permissions to all users. On Computer1, configure each user's profile path to a folder in the shared folder. 
• C、Create a shared folder on Server1.  Assign Full Control permissions to all users. On Computer1, configure each user's home folder path to a folder in the shared folder. 
• D、On Computer1, map a drive from each client computer to an administrative share on Server1.  Configure each user's home folder path to point to the mapped drive. 

第10题：

第11题：

第12题：

第13题：

An administrator has received an update CD with the latest technology level for AIX 5.3. The current operating system level of the server is at base AIX 5.3. What action needs to be taken to apply the new technology level to the server？（）

• A、Run smit update_all
• B、Run smit install_all
• C、Boot from the installation media
• D、Run the update_all command from the mounted CD

第14题：

A technician is troubleshooting a CD/DVD drive. There is a disk in the drive and the tray wont eject. Which of the following actions should the technician take FIRST？ （）

• A、Shutdown， restart and verify that the BIOS recognizes the drive and try again.
• B、Replace the CD/DVD drive.
• C、Pry the tray open with a small， flat head screwdriver.
• D、Place the end of a paper clip in the emergency eject pinhole on the CD/DVD drive.

第15题：

A user has recently added a second IDE CD-RW drive to a machine in addition to the primary DVD-ROM drive. The drive opens and closes; however, they do not see it show up in Windows. Which of the following is the MOST likely cause?（）

• A、The drive jumper settings are incorrect.
• B、The drive is not receiving power from PSU.
• C、Windows only supports one optical drive.
• D、The user connected the drive with a SATA cable.

第16题：

An administrator only has one public IP address that must be shared among five employees. Which of the following network schemes should be used?（）

• A、SNAT
• B、SNAP
• C、NAC
• D、MPLS

第17题：

Which of the following procedures should be performed to run diagnostics in single-user mode? （）

• A、 Run standalone diagnostics from the cd. 
• B、 Run standalone diagnostics from the AIX tape. 
• C、 Run maintenance mode diagnostics from the hard drive. 
• D、 Run maintenance mode diagnostics from the diskette. 

第18题：

Best practices would have no single point of failure between mirrored resources. In setting up virtual, internal boot disks for two client LPARs, how would this be accomplished?（）

• A、Have one VIO server with striped disks for all LPARs
• B、Have one VIO server with mirrored disks for all LPARs
• C、Have two VIO servers with each LPAR accessing both VIO servers
• D、Have two VIO servers with each LPAR accessing a different VIO server

第19题：

A system administrator wants to perform some system maintenance. The AIX installation CD is in the CDROM drive， however the system will not boot from the CD. Which command will assist in determining if the CDROM drive is currently a bootable device？（）

• A、lscfg -l cd0 -v
• B、bootlist -m service -o
• C、bosboot -a -d /dev/cd0
• D、chdev -l cd0 -a boot=yes

第20题：

You are the network administrator for TestKing. The network consists of a single Active Directory domain that contains five member servers running Windows 2000 Server. All five servers have CD-ROM drives and floppy disk drives. You purchase a new computer that has a CD-RW drive. This computer does not currently have a floppy disk drive, but you plan to install one eventually. You install and configure Windows Server 2003 and Recovery Console on the new computer. You configure it as a member server named Testking6. Now you need to ensure that Testking6 can be restored in the event of an operating system failure. Which two actions should you perform? （）(Each correct answer presents part of the solution. Choose two.)

• A、Copy Asr.sif, Asrpnp.sif, and Autorun.exe from the appropriate directories on Testking6 to another server. Copy the same files to a CD-Rom.
• B、Copy Asr.sif and Asrpnp.sif from the appropriate directory on Testking6 to another server. Copy the same files to a floppy disk.
• C、Start the Automated System Recovery wizard on Testking6.
• D、Start the Create an Emergency Repair Disk wizard on Testking6.
• E、Copy Autoexec.nt, Config.nt, Setup.log, and Autorun.exe from the appropriate directories on Testking6 to another server. Copy the same files to a CD-Rom.
• F、Copy Autoexec.nt, Config.nt, and Setup.log from the appropriate directories on Testking6 to another server. Copy the same files to a floppy disk.

第21题：

An A+ Certified Technician MUST do an install on a Windows XP system from the distribution CD. However， the system does not boot from this CD. What is the MOST likely cause of this problem？（）

• A、The CD is defective.
• B、The CD is not bootable.
• C、The CD-ROM drive is defective.
• D、The Boot Sequence is not set in the BIOS to boot first from the CD

第22题：

第23题：