A technician has installed a new motherboard in a workstation, but after hardware tests, themotherboard has failed. Which of the following should the technician do FIRST before replacingthe motherboard? ()
第1题:
A technician has installed an additional NIC on a server. Which of the following can now be set up?()
第2题:
A technician installed a new application on a Windows XP desktop. When the technician tries to launch the application it crashes. Which of the following can the technician use to troubleshoot the application?()
第3题:
A technician installed a new application on a Windows XP desktop. After the application wasinstalled, the technician rebooted the desktop and received a bluescreen error. Which of thefollowing steps should the technician perform?() (Select TWO).
第4题:
A system has three different network adapters installed. Which of the following should a technician use to get the details of all the adapters at the same time?()
第5题:
A technician has just completed a CPU upgrade on a motherboard. Which of the following will MOST likely cause the PC not to boot?()
第6题:
A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?()
第7题:
Boot into Safe Mode
Replace the motherboard
Uninstall the application
Replace the hard drive
Install more RAM
第8题:
In the BIOS, the onboard video adapter must be disabled.
The video resolution is set too high.
The LCD panel is defective.
The drivers for the new video card must be installed before installing the card.
第9题:
Use a jumper from the motherboard where the new drive is going to be installed.
Use a jumper from a hard drive that is no longer functioning.
Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.
The new hard drive must be replaced
第10题:
21
23
80
443
第11题:
Flash Drive
DVD-RW
CD-ROM
SSD
第12题:
A new default gateway has been setup.
A new Internet shortcut has been added.
A new web browser has been installed and is now the default.
A proxy server has been enabled.
第13题:
A technician is building a Windows 2008 server and has installed a motherboard, processor, and power supply. Which of the following optical drives should the technician install?()
第14题:
A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?()
第15题:
A technician has installed a secondary hard drive for a computer. However, the hard drive is not appearing under My Computer. The disk is receiving power, and appeared on the POST when Windows started. Which of the following Windows utilities would help configure the new hard disk?()
第16题:
A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?()
第17题:
A technician has just installed an upgraded graphics card. The computers power turns off before itfinishes booting. Which of the following is the cause of the problem? ()
第18题:
A customer has just purchased six x346 servers running Windows 2003 Web Edition.They are expecting to add six additional x346’s in three months.They have a requirement to automatically deploy the current server image upon the new servers. What TWO actions are required to complete this task?()
第19题:
TV tuner codec was not installed.
Not enough RAM to support the TV tuner.
Motherboard is faulty.
Video card drivers are not installed.
第20题:
Reseat all power connections.
Remove the CMOS battery.
Install the graphics card.
Ground to the case.
第21题:
The monitor cannot display the increased resolution that is a feature of the new graphics card.
The power supply does not provide enough wattage to power the new graphics card.
The new graphics card is incompatible with the existing processor.
The computer does not have enough RAM to support the new graphics card.
第22题:
The voltage selector switch on the power supply is set incorrectly.
The 3.3v power line is connected to the wrong input on the motherboard.
The new power supply voltage rating is too high.
The 12v power cord is installed incorrectly.
第23题:
Print spooler has stalled
Device driver has failure
Incorrect form is printing
Incompatible driver is installed
第24题:
The technician used generic thermal paste.
The processor had pins broken during installation.
The memory is incompatible with the new CPU.
An incorrect fan size was installed on the heatsink.