10
5
15
20
第1题:
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem?()
第2题:
On a WLAN controller, what is the default roaming bandwidth percentage reserved for voice clients?()
第3题:
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connectedto awireless controller?()
第4题:
In order for a controller-based access point to be allowed to participate in aggressive loadbalancing,it must have heard the client within how many seconds?()
第5题:
15
10
1
5
第6题:
8
32
4
16
第7题:
20
5
15
10
第8题:
An access point will search for a controller using a broadcast address if using LWAPP Layer 2 and a unicast address if using LWAPP Layer 3 mode.
If multiple wireless controllers are detected by an access point, the controller with the fewest associated access points is chosen to associate with.
In order to associate in Layer 3 mode, the access point must have been preconfigured with an IP address.
Once an access point associates with a controller in LWAPP Layer 3 mode, it receives an IP address from the controller.
An access point first searches for a controller in LWAPP Layer 2 mode. If the search is not successful, the access point then attempts to locate a controller in LWAPP Layer 3 mode.
If multiple wireless controllers are detected by an access point, all of them will be used and traffic will be load balanced.
第9题:
passed by the AP to its connected switch and then forwarded directly to the connected router,which creates an MGID table entry
passed by the AP to the WLAN controller and then forwarded to the source PIM-enabled router,which creates an MGID table entry
passed by the AP to the WLAN controller, which creates an MGID table entry before forwarding to the directly connected PIM-enabled router
passed by the AP to its connected switch and then forwarded to the rendezvous point router,which creates an MGID table entry
第10题:
Which statement is true about the data traffic between the access point named TKAP1 and controller TKC1?()
第11题:
How many radius servers can be added to a controller and thereafter assigned to the authentication or accounting of individual wlan ids?()
第12题:
In order for a controller-based access point to be allowed to participate in aggressive load balancing,it must have heard the client within how many seconds?()
第13题:
10
5
15
20
第14题:
14
15
17
16
第15题:
Enter the clear controller command followed by the reload command.
Enter the clear controller command followed by the reset command.
Enter the clear controller command followed by the reset system command.
Enter the erase startup-config command followed by the reload command.
Enter the erase startup-config command followed by the reset command.
Enter the erase startup-config command followed by the reset system command.
第16题:
two
three
four
one
第17题:
802.11b/g
radio
access point
802.11a
第18题:
The hard drives were not plugged into the server correctly.
The controller driver is outdated and needs to be updated from the OEMs website.
The firmware for the server is too old and does not support the new RAID controller card.
The cable from the controller to the hard drive backplane is not connected.