单选题A customer has two separate storage islands and is planning to implement an SVC to provide forFlashCopy between the two islands. What is the minimum number of inter-switch links （ISLs） thatare required？（）A 0B 1C 2D 4

第1题：

A manufacturing customer has an IBM BladeCenter H chassis with four， HX5 with MAX5 4-socket blades installed. Each blade has the optional Fibre Channel Expansion card. The customer wants redundancy and is going to install the following configuration：  （1）two Brocade 20-Port SAN Switch Modules  （2）two Nortel Networks 1/10 GB Uplink ESM  （3）a redundant AMM  What is the minimum number of power supplies needed for this configuration to have full redundancy？（）

• A、4
• B、3
• C、2
• D、8

第2题：

A customer has two separate storage networks and is planning to implement an SVC to provide for FlashCopy between the two networks. What is the minimum number of ISL ports required?（）

• A、0
• B、1
• C、2
• D、4

第3题：

A customer has two single cluster IBM TS7700 Virtualization Engines at the same site. The customer wants to move one to a remote site and set up a grid configuration with the two clusters. The customer has fibre between the two sites. What is the most important factor to consider when planning the new configuration?（）

• A、operator training
• B、cache size of the two clusters
• C、fibre bandwidth capability between the sites
• D、number of stacked tape drives attached to each cluster

第4题：

A customer is planning to upgrade two VMware ESX servers from 3.5 to 4.1 after recently installing a new XIV Storage System. Each server has 4 HBAs connected to redundant fabrics for a total of 4 paths per server to storage. The customer wants to increase the throughput available to the ESX servers. What configuration setting does the storage specialist need to highlight?（）

• A、increase the buffer credits on the HBAs
• B、increase the number of device logins on the ESX servers
• C、additional paths will be required between the servers and storage
• D、multipath option on the ESX servers should be changed to round-robin

第5题：

An architect is configuring a PowerHA cluster in the following way：The cluster will consist of two nodes. Each node will have two boot interfaces configured as a single PowerHA network. The cluster is to have asingle resource group with a single service address.Heartbeating over aliased is not to be used. What is the minimum number of subnets required to implement this cluster？（）

• A、1
• B、2
• C、3
• D、4

第6题：

A customer has two separate storage islands and is planning to implement an SVC to provide forFlashCopy between the two islands. What is the minimum number of inter-switch links （ISLs） thatare required？（）

• A、0
• B、1
• C、2
• D、4

第7题：

A customer needs to create a number of LPARs on a new POWER6 server with some LPARs requiring a dedicated network and other LPARs utilizing Virtual Ethernet via a VIO server. Which limitation must be considered when planning the system configuration?（）

• A、A VIO server requires a dedicated LHEA port.
• B、There is a limit of 32 LPARs per virtual LAN.
• C、Two VIO servers will be required. A single VIO server can only provide virtual storage or virtual Ethernet.
• D、Two VIO servers will be required. One to provide virtual networking and another to provide dedicated networking.

第8题：

第9题：

第10题：

第11题：

第12题：

第13题：

When planning an SVC environment with the customer， the storage specialist finds that they wishto include iSCSI storage into the cluster. In this situation what is needed to place the storage intoproduction？（）

• A、a RAID card
• B、IQN of the host
• C、amount of storage
• D、number of I/O groups

第14题：

A company needs to connect seven of their Windows-based servers to a DS4000 storage server.   The DS4000 only has two host-side connections， and each server has two HBAs.  Which of the following is the lowest cost solution to provide no single points of failure？（）

• A、Implement two 8-port switches design with ISLs
• B、Implement two 16-port switches design with ISLs
• C、Implement two 8-port switches design without ISLs
• D、Implement two 16-port switches design without ISLs

第15题：

During Company.com planning session，Company.com presents the details of the current  Network design. The network design serves four separate company facilities， each on as separate subnet. As part of a disaster recovery plan， the customer is evaluating the use of HACMP. Specifically， the have reviewed IPAT via IP aliasing and are questioning the number of IP subnets required.  Given the customer’s current configuration，what is the recommended minimum number of IP subnets that would be required？（）

• A、 4
• B、 5
• C、 6
• D、 8

第16题：

A customer is planning to buy a two enclosure Power 770, and will implement 4 LPARs with the following requirements:Each LPAR must have a private, dedicated connection to the network.The adapter for this network connection must be hot-swappable.The customer wants to minimize the number of I/O slots used. Which of the following fulfills the customer requirements?（）

• A、Two dual-port PCIe adapters
• B、A four-port PCIe Ethernet adapter
• C、Four separate PCIe Ethernet adapters
• D、Two embedded Integrated Virtual Ethernet adapters (IVE)

第17题：

A current N series customer has an IBM System Storage N3600. They are interested in futureexpansion. What is the minimum number of disk drives required to populate the expansion shelf？（）

• A、0
• B、1
• C、4
• D、14

第18题：

A customer is planning a PowerHA cluster split across two sites. The sites are located 10km apart. There is aDS8000 storage array at each site with SAN connectivity between the two arrays. There are only enough IPinterfaces for one IP network in this cluster. How can they ensure that disk data is automatically mirrored and synchronized between sites？（）

• A、Purchase PowerHA/XD license
• B、Purchase PowerHA with GLVM license
• C、Implement PowerHA with split-site LVM
• D、Implement PowerHA with cross-site LVM

第19题：

A customer is adding a new p5 machine to their environment.  The machine will host several DB2 partitions running AIX 5.2.  They currently have two SAN directors and an IBM ESS.  The SAN design allows for concurrent maintenance.  What is required on each partition to attach to the SAN？（）

• A、A minimum of two HBAs； the customer will need to download SDD
• B、A minimum of four HBAs； the customer will need to download SDD
• C、A minimum of two HBAs； the customer will need to configure MPIO
• D、A minimum of four HBAs； the customer will need to configure MPIO

第20题：

第21题：

第22题：

第23题：

第24题：