A. Summarize data center subnets.
B. Use passive interfaces to ensure appropriate adjacencies.
C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D. Adjust the default bandwidth value to ensure proper bandwidth on all links.
E. Advertise a default summary route into the data center core from the aggregation layer.
第1题:
Which of these recommendations is most appropriate for the Cisco Campus Architecture?()
第2题:
When EIGRP is used as the PE-CE routing protocol which of these statements is correct?()
第3题:
How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)()。
第4题:
Which statement about data center access layer design modes is correct?()
第5题:
Which two routing protocols require a metric to be configured when redistributing routes from other protocols?()
第6题:
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? ()
第7题:
A network design shows that R1 has four different possible paths from itself to the Data Center subnets. Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?()
第8题:
Utilize Layer 3 switching
Utilize software accelerated services
Aggregate end users and support a feature-rich environment
Perform packet manipulation and filtering at the core layer
Use redundant point to-point Layer 2 interconnections when where is a link or node failure.
第9题:
EIGRP can be used only as the PE-CE routing protocol if the PE and CE routers are in the same AS
Other EIGRP AS routes are automatically advertised to the CE router and do not require a redistribution configuration command to be configured
Unlike other routing protocols that are used between PE and CE routers, EIGRP supports backdoor links
Configure of the VPN is only required on the PE router
第10题:
EIGRP queries will be the most significant issue with respect to stability and convergence
EIGRP queries are not a consideration as long as EIGRP has a feasible successor with a nexthop AD that is greater than the FD of the current successor route
EIGRP queries will only increase the convergence time when there are no EIGRP stubsdesigned in the network
第11题:
The access layer is the first oversubscription point in a data center design.
When using a Layer 2 loop-free design, VLANs are extended into the aggregation layer.
When using a Layer 2 looped design, VLANs are not extended into the aggregation layer.
When using a Layer 3 design, stateful services requiring Layer 2 connectivity are provisionedfrom the aggregation layer.
The data center access layer provides the physical-level connections to the server resourcesand only operates at Layer 3.
第12题:
show ip eigrp topology
show ip eigrp topology all - links
show ip route eigrp
show ip route eigrp all - links
show ip eigrp topology all - learned
第13题:
Which of these recommendations is most appropriate for the core layer in the Cisco Campus Architecture?()
第14题:
Which of the following is true regarding the effect of EIGRP queries on the network design?()
第15题:
Which two design recommendations are most appropriate when EIGRP is the data center corerouting protocol? ()
第16题:
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? ()
第17题:
Which routing protocol by default uses bandwidth and delay as metrics()。
第18题:
The Cisco SDM can configure most, but not all, routing protocols. Which two of these routing protocols can be configured using SDM? (Choose two.)()
第19题:
Routes learned using any IP routing protocol can only be redistributed into non IP routing protocols.
OSPF can import routes learned using EIGRP, RIP, and IS - IS.
OSPF routes cannot be exported into EIGRP, RIP, an d IS - IS.
At the interdomain level, OSPF cannot import routes learned using BGP.
OSPF routes can be exported into BGP.
第20题:
Summarize data center subnets.
Use passive interfaces to ensure appropriate adjacencies.
Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
Adjust the default bandwidth value to ensure proper bandwidth on all links.
Advertise a default summary route into the data center core from the aggregation layer.
第21题:
Never peer on transit links.
Build squares for deterministic convergence.
Build inverted U designs for deterministic convergence.
Summarize routes at the distribution to the core to limit EIGRP queries or OSPF LSA propagation.
第22题:
If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.
第23题:
Utilize Layer 3 switching.
Utilize software accelerated services.
Aggregate end users and support a feature-rich environment.
Perform packet manipulation and filtering at the core layer.
Use redundant point-to-point Layer 2 interconnections when there is a link or node failure.