A. It routes all traffic that is addresses to the destination network to the interface indicates in the routing table.
B. It sends a copy of its neighbor table to all adjacent routers.
C. It sends a multicast query packet to all adjacent neighbors requesting available routing paths to the destination network.
D. It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.
第1题:
After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?()
第2题:
Which statements are true about EIGRP successor routes?()
第3题:
A router has been configured with an EIGRP variance of 3. Which of the following statements istrue?()
第4题:
Which two statements are true regarding EIGRP?()
第5题:
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?()
第6题:
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4?()
第7题:
ping
trace
show ip route
show interface
show cdp neighbors
第8题:
a primary route,stored in the routing table
a backup route,stored in the routing table
a backup route,stored in the topology table
a primary route,stored in the topology table
第9题:
An error will result because a router cannot be configured with an EIGRP variance of 3 becausethe maximum variance number is 2
The successor route will end up in the routing table, and so will any route with a metric at mostthree times greater than the value of the successor’s metric
EIGRP will only advertise routes that are within three hops of the current router
The successor route will end up in the routing table, and so will any route with a metric at leastone third the value of the successor’s metric
The best three routes with equal cost paths will end up in the routing table
The successor route will be any route with three times the value of the advertised distance
第10题:
It establishes a static route to the 172.16.3.0 network.
It establishes a static route to the 192.168.2.0 network.
It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.
It uses the default administrative distance.
It is a route that would be used last if other routes to the same destination exist.
第11题:
EIGRP will automatically use the route with the lowest advertised distance (AD) .
The route will transition to the active state.
The route will transition to the passive state.
EIGRP will find the interface with the lowest MAC address.
EIGRP will automatically use the route with the lowest feasible distance (FD).
第12题:
A successor route is used by EIGRP to forward traffic to a destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
第13题:
Which of the following is true regarding the effect of EIGRP queries on the network design?()
第14题:
Which statements are true about EIGRP successor routes? ()
第15题:
A router has EIGRP configured as the only routing protocol. How does EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?()
第16题:
Which statements are true about EIGRP successor routes (Choose two.)()。
第17题:
What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is inactive status?()
第18题:
While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?()
第19题:
It routes all traffic that is addresses to the destination network to the interface indicates in the routing table.
It sends a copy of its neighbor table to all adjacent routers.
It sends a multicast query packet to all adjacent neighbors requesting available routing paths to the destination network.
It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.
第20题:
A successor route is used by EIGRP to forward traffic to a destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
Successors are not used in EIGRP.
第21题:
It immediately sends its entire routing table to its neighbors.
EIGRP sends a Hello packet to the DR to inform it of the route failure.
It automatically forwards traffic to a fallback default route until a successor route is found.
It sends queries out to neighbors until a new successor route is found.
It places the route in holddown until LSA updates inform it of a new route to the network.
第22题:
Passive routes are in the process of being calculated by DUAL.
EIGRP supports VLSM, route summarization, and routing update authentication.
EIGRP exchanges full routing table information with neighboring routers with every update.
If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route.
A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information.
第23题:
A successor route is used by EIGRP to forward traffic to destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
第24题:
EIGRP queries will be the most significant issue with respect to stability and convergence
EIGRP queries are not a consideration as long as EIGRP has a feasible successor with a nexthop AD that is greater than the FD of the current successor route
EIGRP queries will only increase the convergence time when there are no EIGRP stubsdesigned in the network