A network administrator repeatedly receives support calls about network issues. After investigating the issues, the administrator finds that the source NAT pool is running out of addresses.To be notified that the pool is close to exhaustion, what should the administrator configure?()
A. Use the pool-utilization-alarm raise-threshold under the security nat source stanza.
B. Use a trap-group with a category of services under the SNMP stanza.
C. Use an external script that will run a show command on the SRX Series device to see when the pool is close to exhaustion.
D. Configure a syslog message to trigger a notification when the pool is close to exhaustion.
第1题:
An enterprise h as plans to start adding IPv6 support. For the first year, the IPv6 will be in small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic while applications teams test IPv6 - enabled servers and applications.Which of the fol lowing tools would be most appropriate?()
A. Native IPv6
B. Point - to -point tunnels
C. Multipoint tunnels
D. NAT - PT
第2题:
A.network 172.26.168.0 area 478
B.network 172.26.0.0
C.network 172.26.168.128 0.0.0.127
D.network 172.26.168.128 area 478
第3题:
下列命令中,正确的是:
A.network 172.16.1.0 0.0.0.255 area 1
B.network 172.16.1.0 255.0.0.0 area 0
C.network 172.16.0.0 255.255.0.0 area 0
D.network 172.16.1.0 255.255.255.0 area 1
第4题:
The Testking Network consists of the following 5 IP networks:NETWORK 1: 192.168.10.0/26NETWORK 2: 192.168.10.64/27NETWORK 3: 192.168.10.96/27NETWORK 4: 192.168.10.128/30NETWORK 5: 192.168.10.132/30Which of the following routing protocols will support this IP addressing scheme?()
A. RIP version 1
B. RIP version 2
C. IGRP
D. EIGRP
E. OSPF
F. BGP
第5题:
Which routing protocols will support the following IP addressing scheme? ()Network 1 - 192.168.10.0 /26Network 2 - 192.168.10.64 /27Network 3 - 192.168.10.96 /27Network 4 - 192.168.10.128 /30Network 5 - 192.168.10.132 /30
A.RIP version 1
B.RIP version 2
C.IGRP
D.EIGRP
E.OSPF
第6题:
【单选题】要在路由器 B 上为所有相连网络启用 RIP,正确的命令是怎样的?
A.RouterB# router rip RouterB(router)# network 210.36.7.0 RouterB(router)# network 220.17.29.0 RouterB(router)# network 211.168.74.0
B.RouterB(config)# router rip RouterB(config-router)# network 198.16.4.0 RouterB(config-router)# network 211.168.74.0 RouterB(config-router)# network 199.84.32.0
C.RouterB(config)# configure router rip RouterB(config-router)# network 210.36.7.0 RouterB(config-router)# network 199.84.32.0 RouterB(conf