itgle.com

Which configuration component is required to allow a PPP over ATM client to connect to one virtual router for a particular session and to a different virtual router for another session?()A. profileB. domain mapC. IP access-routeD. static IP addressing

题目
Which configuration component is required to allow a PPP over ATM client to connect to one virtual router for a particular session and to a different virtual router for another session?()

A. profile

B. domain map

C. IP access-route

D. static IP addressing

相似考题

1.Hibernate中核心接口有()A.Session接口B.SessionFactory接口C.Configuration接口D.Callback接口

2.假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图5-17所示。结合图 5-15所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config)vpdn enableRouter_LAC(config) (5) (创建相应vpdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual—template 1创建virtual-access接口)Router_LAC(config-vpdnl) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdnl)12tp tunnel password! abcd1234!(8)Router_LAC(config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)

3.Which IDP policy action closes the connection and sends an RST packet to both the client and the server?()A. close-connectionB. terminate-connectionC. close-client-and-serverD. terminate-session

4.假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图8-18所示。结合图 8-16所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config) vpdn enableRouter_LAC(config) (5) (创建相应vPdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual-template 1创建virtual-access接口)Router_LAC(config-vpdn1) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdn1) 12tp tunnel password !abcd1234!(8)Router_LAC (config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)

更多“Which configuration component is required to allow a PPP over ATM client to connect to one virtual router for a particular session and to a different virtual router for another session?() ”相关问题

  • 第1题：

    Which three statements are correct regarding the CLI command, 12tp destination profile to－NewYork virtual－router vr1 ip address 1.1.1.1 ? ()(Choose three.)

    A. LNS IP address is defined.

    B. LAC IP address is defined.

    C. Virtual-router vr1 sends and receives L2TP traffic.

    D. Virtual-router vr1 is the authenticating virtual-router.

    E. This command is performed on the LNS.


    参考答案：B, C, E

  • 第2题：

    Which command will delete the current rescue configuration?()

    A. user@router# system delete configuration rescue

    B. user@router> request system configuration rescue delete

    C. user@router# delete rescue configuration

    D. user@router> file delete rescue-configuration


    参考答案：B

  • 第3题：

    3、【STCS_03_2】配置PPP验证方式为chap的命令为：

    A．Router(config)#encapsulation ppp chap

    B．Router(config-if)#encapsulation chap

    C．Router(config-if)#ppp authentication chap

    D．Router(config-if)#encapsulation ppp chap


    错误

  • 第4题：

    The output of the show aaa domain-map displays the following information:Domain: isp1.com; virtual-router: vr1; loopback: 1Domain: isp2.com; virtual-router: vr2; loopback: 1Domain: none; virtual-router: vr3; loopback: 1Domain: default; virtual-router: vr4; loopback: 1The end user supplies a login name of joe@isp7.com .Which virtual router is responsible for authenticating this user?（）

    A. vr1

    B. vr2

    C. vr3

    D. vr4


    参考答案：D

  • 第5题：

    Refer to the exhibit. During the process of configuring a virtual link to connect area 2 with the backbone area, the network administrator received this console message on R3:*Mar 1 00:2 5:01.084: %OSPF -4- ERRRCV: Received invalid packet: mismatch area ID, from backbone area must be virtual link but not found from 20.20.20.1, Serial 0 .How should the virtual link be configured on the OSPF routers to establish full connectivity between the areas?（）

    A.R1(config - router)# area 0 virtual - link 1.1.1.1R3(config - router)# area 2 virtual - link 3.3.3.3

    B.R1(config - router)# area 1 virtual - link 2.2.2.2 R3(config - router)# area 1 virtual - link 2.2.2.2

    C.R1(config - router)# area 1 virtual - link 20.20 .20.2 R3(config - router)# area 1 virtual - link 30.30.30.2

    D.R1(config - router)# area 1 virtual - link 30.30.30.3 R3(config - router)# area 1 virtual - link 20.20.20.1

    E.R1(config - router)# area 1 virtual - link 3.3.3.3 R3(config - router)# area 1 virtual - link 1.1 .1.1


    参考答案：E

  • 第6题：

    2、【STCS_03_2】给接口配置PPP协议的命令：

    A．Router(config)#encapsulation ppp

    B．Router(config-if)#encapsulation ppp

    C．Router(config-if)#encapsulation pap

    D．Router(config-if)#encapsulation ppp pap


    传输距离短;有电平偏移;抗干扰能力差

相关内容