A Fibre Channel fabric (or Fibre Channel switched fabric, FC-SW) is a switched fabric of Fibre Channel devices enabled by a Fibre Channel switch. Fabrics are normally subdivided by Fibre Channel zoning.Each fabric has a name server and provides other serv

第1题：

In a Cisco Unified Computing System， where are SAN port channels connected to？（）

• A、 Only to Cisco Fibre Channel switches
• B、 Only to Cisco Fibre Channel switches in NPIV mode
• C、 To any Fibre Channel switch
• D、 Directly to storage arrays
• E、 Only to Nexus Switches

第2题：

A Fibre Channel fabric （or Fibre Channel switched fabric， FC-SW） is a switched fabric of FibreChannel devices enabled by a Fibre Channel switch. Fabrics are normally subdivided by Fibre Channel zoning. Each fabric has a name server and provides other services. Higher redundancy over FC-AL，P2P.Which path selection protocol is used by Fibre Channel fabrics？（）

• A、 OSPF
• B、 RIP
• C、 FSPF
• D、 VSANs

第3题：

Which command is used to determine if a host has logged in to the Fibre Channel fabric？ （）

• A、 show flogi database
• B、 show system fc login
• C、 show npv flogi-table
• D、 show npv fcns database
• E、 show interface vfc X flogi
• F、 show interface flogi

第4题：

Fibre Channel， or FC， is a gigabit-speed network technology primarily used for storage networking.Fibre Channel is standardized in the T11 Technical Committee of the InterNational Committee forInformation Technology Standards （INCITS）， an American National Standards Institute （ANSI）Caccredited standards committee. Which two of these correctly describe Fibre Channel？ （）

• A、 supports multiple protocols
• B、 works only in a shared or loop environment
• C、 allows addressing for up to 4 million nodes
• D、 provides a high speed transport for SCSI payloads

第5题：

Which statement about Cisco Unified Fabric switches is correct？ （）   

• A、 The Nexus 5000 family of switches does not support vPC when running in either NPV or FCoE NPV mode.
• B、 The MDS 9100 family of switches is an excellent design choice as a Unified Fabric edge switch. 
• C、 The Nexus 7000 Series Switches can support the NPIV mode of operation， but cannot function as a complete Fibre Channel Forwarder.
• D、 The Nexus 7000 Series Switches cannot support advanced Cisco Fibre Channel features such as IVR.
• E、 The MDS family of Cisco Unified Fabric switches supports both the Fibre Channel Forwarder and Fibre Channel Bridge functions.

第6题：

Which path selection protocol is used by Fibre Channel fabrics？（）

• A、 IVR
• B、 VoQ
• C、 FSPF
• D、 VSANs
• E、 SANTap

第7题：

A customer is ready to order a pSeries solution.  However， the pSeries technical specialist is unsure whether the customer preferred the fibre channel or the external SCSI disk attachment option.  What is the most appropriate action for the specialist to take next？（）

• A、Ask the customer to confirm which option is best for their environment.
• B、Order the fibre channel option and purchase a converter later if necessary.
• C、Order both SCSI and fibre channel adapters to cover both potential options.
• D、Inform the customer that fibre channel was selected for performance reasons.

第8题：

An administrator wants to have the flexibility to dynamically move a fibre channel PCI card between given LPARs. For each given LPAR how should they add the PCI card to the LPAR profile?（）

• A、Add the fibre channel card as hared?Add the fibre channel card as ?hared?
• B、Add the fibre channel card as irtual?Add the fibre channel card as ?irtual?
• C、Add the fibre channel card as esired?Add the fibre channel card as ?esired?
• D、Add the fibre channel card as equired?Add the fibre channel card as ?equired?

第9题：

A customer is deploying a new database on a PS701 Blade in a BladeCenter H, and requires redundant network and SAN adapters. Which configuration supports the customer requirement?（）

• A、Configure 2 CFFh combination fibre channel / gigabit Ethernet adapters
• B、Configure 1 CFFh 2-port fibre channel adapter and 1 CIOv 2-port gigabit Ethernet adapter
• C、Configure 1 CIOv 2-port fibre channel adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter
• D、Configure 1 CIOv 2-port gigabit Ethernet adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter

第10题：

第11题：

第12题：

第13题：

What is the appliance port used to connect to in a Cisco Unified Computing System？（）

• A、 Fibre Channel storage
• B、 UCS C-Series servers
• C、 NFS storage
• D、 UCS chassis
• E、 Other fabric interconnect

第14题：

Which statement describes multihop FCoE function when an FCoE switch receives an FCoE frame from the directly connected FCoE host？（）

• A、 The switch receives the FCoE frame and forwards it to another switch over its VE port.
• B、 The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the fabric over its Fibre Channel uplink port.
• C、 The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the Fibre Channel target over its Fibre Channel port.
• D、 The switch receives the FCoE frame and forwards it to another FCoE device over its VN port.

第15题：

Which of the following describes the advantage of using Fibre Channel over Ethernet （FCoE） in POWER6 and POWER7 Blades？（）

• A、The FCoE card provides both LAN and fibre channel function from a single card on the blade. 
• B、The FCoE advanced technology removes the need for any BladeCenter switching to support this function.
• C、Component reliability on the fibre channel over Ethernet is higher than on regular Ethernet and fibre channel adapters.
• D、The AIX device driver for FCoE has been completely rewritten for the current adapter， eliminating errors and performance issues.

第16题：

A customer wants to install an IBM BladeCenter infrastructure but is concerned about the cost of the full fabric internal fibre switches. Consequently， the customer is considering an N_Port ID Virtualization （NPIV） capable switch. Which of the following should be mentioned to the customer regarding the NPIV switch？（）

• A、Youcan not use an NPIV switch in the same IBM BladeCenter chassis as a Cisco Intelligent Ethernet Switch
• B、Using blade servers with the NPIV switch will require morefibre ports on the external fibre switch
• C、Storage devices likeFibre Channel Tape and Disk cannot be attached to the NPIV Switch but must connect to a core fabric switch.
• D、The NPIV switch will count against the number of domains in a fabric

第17题：

Which two Fibre Channel features are not supported in Cisco Nexus 5500 and Nexus 5000 platforms？ （）

• A、 port security
• B、 fabric binding
• C、 IVR
• D、 port tracking
• E、 FICON

第18题：

What types of host connectivity are available on the Storwize V7000?（）

• A、Fibre Channel and SAS 
• B、Fibre Channel and iSCSI 
• C、Fibre Channel, iSCSI and SAS 
• D、Fibre Channel, iSCSI and InfiniBand 

第19题：

A customer is deploying a new database on a PS701 Blade in a BladeCenter H, and requires redundant network and SAN adapters. Which configuration supports the customer requirement?（）

• A、Configure 2CFFh combination fibre channel / gigabit Ethernet adapters
• B、Configure 1CFFh 2-port fibre channel adapter and 1 CIOv 2-port gigabit Ethernet adapter
• C、Configure 1CIOv 2-port fibre channel adapter and 1 CFFh combination fibre channel / gigabit Ethernet  adapter
• D、Configure 1CIOv 2-port gigabit Ethernet adapter and 1 CFFh combination fibre channel / gigabit Ethernet  adapter

第20题：

A customer wants to install an IBM BladeCenter infrastructure but is concerned about the cost of the full fabric internal fibre switches. Consequently, the customer is considering an N_Port ID Virtualization (NPIV) capable switch.Which of the following should be mentioned to the customer regarding the NPIV switch?（）

• A、You can not use an NPIV switch in the same IBM BladeCenter chassis as a Cisco Intelligent Ethernet Switch 
• B、Using blade servers with the NPIV switch will require more fibre ports on the external fibre switch 
• C、Storage devices like Fibre Channel Tape and Disk cannot be attached to the NPIV Switch but must connect to a core fabric switch
• D、The NPIV switch will count against the number of domains in a fabric

第21题：

第22题：

第23题：

第24题：